1·The result of this shearing force is to push the endoplasm forward.
这种剪切力作用的结果是推动内质向前。
2·Decreasing the particle size is usually conducted by applying a shearing force.
通常使用剪切力减小颗粒粒度。
3·The distribution of storey shearing force in frame-shear wall structure is discussed.
讨论了框剪结构在弹性和弹塑性工作状态下楼层剪力的分配机理。
4·However, under cyclic shearing force, brick masonry also undergoes evident hysteretic behaviour.
其实，砌体在周期性剪力作用下具有显著的滞回性质。
5·This article introduces how to make the band saw sensor of measured shearing force and its structure.
文中介绍了带锯切削力传感器的结构、制做方法。
6·The firmness, elasticity and shearing force of bread by rheometer during storage of bread were determined.
采用流变仪测定了面包在贮存期间的硬度、弹性及剪切力的变化。
7·Reasonable design of shear connector need availably control of horizontal shearing force between steel webs.
合理地设计抗剪连接件需要有效地控制钢腹板和混凝土材料之间的水平剪切力。
8·It is concluded that exerting the vibration when shearing, the shearing force and work will be obviously decreased.
结果表明：剪切时施加振动，会显著减小剪切力和剪切功。
9·Interactions among Oxial force, fending moment and shearing force are considered in the generalized yield function.
所采用的广义屈服函数中考虑了轴力、弯矩、剪力、扭矩的交互作用。
10·The longitudinal shearing force of running vehicles (LSFRV) is computed and the mechanism of pavement damage studied.
研究了行车纵剪力计算与损伤路面的机理。
1·The theoretical design and calculation of the circular-section I-shaped beam shearing force sensor have been emphasized in this paper.
本文着重论述了圆截面工字梁剪力传感器的理论设计与计算。
2·The shearing force wall which may affect collapse of building was shut off in advance on the basis of safe construction.
在不影响施工安全的前提下，对有可能影响楼房倒塌的剪力墙做了必要的预处理。
3·The vertical pressure acted on rod is also studied. Its size and distribution rules confirm the shearing force theory.
对拉杆上所受的垂直压力进行了研究，其大小及分布规律有力地验证了剪力理论。
4·Meanwhile, in the superposition beat shearing force wall, the precast block and the core concrete part can work cooperatively.
叠合板式剪力墙中，预制板与核心混凝土部分能够较好地共同工作。
5·The characteristic equations are established by using the boundary conditions, continuous conditions of the displacements and equilibrium conditions of the shearing force and moment in each region.
利用边界条件、区间位移连续性条件和弯矩剪力平衡条件建立了反分析的特征方程序。